Celtic Knot Coaster Set with Holder, 3D Printed Drinks Coasters, 100 mm

Set of round coasters with a raised Celtic knot worked across the face, supplied with a matching stacking holder so the set stays together on the table. Handmade to order on the Isle of Wight. The interlaced knotwork stands proud of the surface, giving the coaster a carved look rather than a printed one, and each coaster is solid underneath. The holder keeps the stack tidy between uses, which is usually the difference between coasters being used and coasters being lost down the side of the sofa. Size Each coaster is approximately 100 mm across. The set with its holder stands approximately 25 mm tall, so roughly 10 x 10 x 2.5 cm together. Material 3D printed in tough PLA, a rigid plastic. The finish in the main photograph is a wood effect. Other colourways are shown in the further photographs as examples. What you receive One coaster set with its holder, in a single colourway of your choosing. Drinks, glasses and anything else shown in the photographs are not included. If you would like a particular number of coasters, please message before ordering. Colour Made to order in the colour you choose. Please message before ordering with the colour or finish you want so it can be confirmed before printing. Please note Each piece is printed individually to order rather than moulded, so you may see faint layer lines or small variations in the finish. These are for cold and warm drinks. PLA softens in heat, so do not stand freshly boiled kettles, hot pans or anything straight off the hob on them, and do not put them in a dishwasher. Wipe clean with a dry or slightly damp cloth. The raised knotwork holds a little liquid in the recesses, so dry them before stacking. This product is not a toy. Keep out of reach of small children. Made to order by 3D Printz IOW on the Isle of Wight.