Wall Mounted Spray Bottle Holder, Trigger Bottle Rack, 75 x 75 x 25 mm

Wall bracket that holds a trigger spray bottle by its neck, so cleaning sprays hang up instead of crowding a worktop or falling over under the sink. Handmade to order on the Isle of Wight. The bottle slots in from above and hangs with the trigger clear, which means you lift it off one handed. Fitted inside a cupboard door, on a utility wall, in a garage, a shed, a salon or a valeting bay, it turns a row of leaning bottles into a tidy line and frees the shelf underneath. Size Approximately 75 mm wide, 75 mm deep and 25 mm thick, which is 7.5 x 7.5 x 2.5 cm. Fits standard trigger spray bottle necks. Bottle shapes vary, so please measure your own before ordering. Material 3D printed in tough PLA, a rigid plastic. What you receive One holder. Bottles and fixings are not included. Please message before ordering if you would like advice on mounting. Colour Made to order in the colour you choose. Please message before ordering with the colour you want so it can be confirmed before printing. Please note Each piece is printed individually to order rather than moulded, so you may see faint layer lines or small variations in the finish. Wipe off any product that runs down the bottle, as some cleaning chemicals and solvents can mark or soften plastic. Keep away from strong heat and direct sunlight. This product is not a toy. Keep out of reach of small children. Made to order by 3D Printz IOW on the Isle of Wight.