Desk Headphone Holder Hook, Under Desk Headset Hanger, No Tools Needed

Headphone hook that slides over the edge of a desk, table or shelf and holds a headset clear of the worktop. No tools, screws or adhesive needed. Handmade to order on the Isle of Wight. The hook hangs the headband so the earcups are not resting on the desk, which keeps the cushions off spills and crumbs and stops the cable tangling under the keyboard. It suits a gaming setup, a home office or a studio desk, and it lifts off again without leaving a mark. Size and fit Approximately 65 mm wide, 50 mm deep and 20 mm tall, which is 6.5 x 5 x 2 cm. The opening is 25 mm, so it fits desk, table and shelf edges up to 25 mm thick. Please measure your desktop before ordering. Material 3D printed in tough PLA, a rigid plastic suited to dry indoor use. What you receive One headphone hook. Headphones and anything else shown in the photographs are not included. Colour Custom colours are available on request. Please message before ordering if you want a particular colour so it can be confirmed before printing. Please note Each piece is printed individually to order rather than moulded, so you may see faint layer lines or small variations in the finish. This is normal for 3D printing. Wipe clean with a dry or slightly damp cloth. Keep away from strong heat and direct sunlight. This product is not a toy. Keep out of reach of small children. Made to order by 3D Printz IOW on the Isle of Wight.